Home | View Cart | Support | Forum | Free Stuff! | Freight | GST Free | Flexirent | GPS Q&A 

Current Category Mounts-Cradles-Brackets > RAM Mounts > RAM Mounts for Bikes

	RAM Mount RAP-274U RAM Mount Part # RAP-274U The RAM Rail Mount consists of a locking tooth system with a standard RAM diamond plate end. The mount will fit a rail diameter from 1.0" to 1.1". To mount to a circular rail, simple press the composite U clamp around the rail and then connect and tighten the small nut and bolt to close the U clamp. Next connect the diamond plate to the mounted clamp at the required angle and screw in the other bolt through the diamond plate. Now you are ready to connect any of the RAM Composite HOL Cradles or any other cradle with two holes positioned 1.912" center to center. Placing a rubber lining (not included) between the tube and the mount for a tube with a diameter less than 1" will help the base grab the rail. NOTE: You cannot rotate the diamond plate on the U clamp when the cradle is connected.

	RAP-274-1U RAM Mount Part# RAP-274-1U Designed for the motorbike or boat to provide a low profile version of the RAM-B-149 series.  Similar Garmin low profile Bike/Boat mounts are GPS specific, meaning the Garmin version includes the cradle for handlebars 24mm or less.  Handlebars/rails 25mm to 34mm require the adapter 010-10496-00 as well.

	RAM Mount for motorbikes or boats by bolting to the hanlebar or rail. RAM-B-149U RAM Mount Part# RAM-B-149U Designed for bolting to a motorbike or boat via the handlebar or rail.  Has Stainless Steel U-Bolt and nuts.

	RAM Mount RAM-B-231ZU - For handlebars/rails between 0.75" - 1.25". RAM Mount Part# RAM-B-231Z Designed for bolting to a motorbike or boat via the handlebar or rail.  Has Zinc coated U-Bolt and nuts.